Part #: PHM-G002
The PhantoMount X2 Gimbal from Phoenix Flight Gear frame and mounting plate is made entirely of 1.5mm carbon fiber. Designed to work on many platforms this gimbal utilizes two HiTec 5245MG Digital Ball Bearing servos directly mounted to both the pitch and roll axis of the camera. This reduces overall weight, fewer moving parts and greatly simplifies the design of the gimbal. Purchase the carbon fiber Rc-Drones F450/550 Flamewheel Legs and raise your F450 3.25" off the ground allowing 1.5" of clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal Stabilization built into the DJI Naza or Wookong flight controller you can directly power and control the gimbal. No additional expensive stabilization controller is needed.
Installation onto your DJI F450 is easy too. Orient your bottom plate so that the bottom plate "wings" are to the front and back (see pics, reconfiguration of your F450 airframe and settings may be required). Attach the legs to each arm, mount the gimbal to the bottom of your DJI F450 with the included hardware and connect to your flight controller. Set up and tune the gimbal in the DJI Assistant Software and film where you fly!
Phoenix Flight Gear recommends that you power your PhantoMount X2 gimbal servos through a 6v BEC harness. This will provide smoother reaction and cleaner videos.
**HERO 3 GO PRO CAMERA AND DJI F450 NOT INCLUDED**
- Unassembled PhantoMount X2 F450 2 Axis gimbal
- Two mini servos